You can work out where to install your wall mounted door stop by holding the door stop against the wall and bringing the door close to it. Make sure that the door stop isn’t set too high or low. Also choose a position that isn’t too far away or close to the end of the door.
Step 2. Drill a pilot hole
Before you drill a pilot hole, place the rod section of the door stop flush to the skirting board where you want to install it. Then using your drill put the drill bit through the hole in the rod and make a shallow hole in the skirting board. After removing the rod, drill deep enough into the skirting board so that the screw will fit securely.
Step 3. Assemble and install the door stop
Put the screw through the rod section of the door stop. Then slide the baseplate onto the screw. Use the screwdriver to securely attach the doorstop to the wall. Insert the rubber stopper at the end of the door stop to prevent it from damaging the door.
D&D Hardware Manufacture of high quality hardware for Wooden Doors, Metal Doors, Escape Doors,Fire Rated Doors,Single Fire Rated Flush Doors, Double Doors,Security Doors, Louver Steel Doors etc.
English
: +86-139 2903 7292
